Page 7 of 8
Re: Building the KLyball 600D
Posted: Thu Apr 11, 2019 1:05 pm
by waltermixxx
Here is the "final" build: (waiting on space bar stabilizer from amazon). Soldering the keys in was not too much of a hassle,
soldered in 1 pin of each switch, then adjusted each key straight and resoldered the pin, and then the second one.
- IMG_0295.JPEG (1.14 MiB) Viewed 9364 times
- IMG_0294.JPEG (1.05 MiB) Viewed 9364 times
Re: Building the KLyball 600D
Posted: Thu Apr 11, 2019 1:35 pm
by dave
That looks fantastic!
Re: Building the KLyball 600D
Posted: Thu Apr 11, 2019 2:36 pm
by waltermixxx
Thank you
Colour add on card is next.
going to point to point solder this, and see how I make out.
Re: Building the KLyball 600D
Posted: Thu Apr 11, 2019 3:18 pm
by Jeff
Congrats!!!
/J
Re: Building the KLyball 600D
Posted: Thu Apr 11, 2019 11:17 pm
by waltermixxx
Serial port Settings for the REV. D.
to use the 600 REV. D at 9600 what changes need to be made?
pin 11 to 11, was changed to pin 2 to pin 11. Just wondering what
modifications need to be made to run at 9600?
(It's Bluetooth time!)
Cheers.
Steve Provided the info:
the mod is the same, except no track to cut, Pin 2 of U30 to Pin 2 of U57
and that's 9600 baud.
Re: Building the KLyball 600D
Posted: Fri Apr 12, 2019 5:40 am
by Klyball
Don't forget the j3 config is different the info is back in the thread
Re: Building the KLyball 600D
Posted: Fri Apr 12, 2019 2:50 pm
by waltermixxx
I will hard wire it for 9600 baud and just serial out. Yup I saw the post you were talking about with the switch. :0). Serial port testing later today.
Re: Building the KLyball 600D
Posted: Fri Apr 12, 2019 4:58 pm
by Jeff
Please link the info/thread.
/J
Re: Building the KLyball 600D
Posted: Fri Apr 12, 2019 10:37 pm
by waltermixxx
here is the link:
http://www.osiweb.org/osiforum/viewtopi ... 0&start=23
this same thread page 3 looks like the 23rd post.
this link should take you right to it.
Re: Building the KLyball 600D
Posted: Sat Apr 13, 2019 4:37 pm
by Jeff
Thanks, Walter.
/J