Is this a home made data separator?

Post Reply
lowrybt1
Posts: 212
Joined: Sun Mar 08, 2015 3:42 pm
Location: New York State

Is this a home made data separator?

Post by lowrybt1 »

Found this online. A13 board with one flat edge 34-pin slot connector and one 34-pin IDE (type) connector. Any thoughts on whether the item attached to the A-13 is a data separator? (see attachment)
20181014_165212.jpg
20181014_165212.jpg (751.77 KiB) Viewed 6689 times
C8PDF w. 48K, 2x 520 24K RAM boards and Glitchworks 64K board
OSI 567 Telephony board
Spare 8" drives
Klyball D-13
RedskullDC
Posts: 62
Joined: Thu Jul 18, 2013 11:24 am
Location: Dorrigo, NSW , Australia

Re: Is this a home made data separator?

Post by RedskullDC »

Hi,

Does look like it, yes.

The 74LS123 one shot could certainly be configured to create the necessary pulse, along with the 74LS38 to isolate the clock and data signals.

Cheers,
Leslie
Superboard II - RevD, 8Kb, DABUG monitor ROM.
C1P - RevD, 610, 2 drives, CEGMON.
FPGA C1P/C2/C4. 1-8MHz, 48Kb ram, CEGMON, 16KB Hires.
dave
Site Admin
Posts: 710
Joined: Tue Sep 09, 2008 5:24 am

Re: Is this a home made data separator?

Post by dave »

I agree, it does look like a data separator. Do you happen to have a link to the site?
lowrybt1
Posts: 212
Joined: Sun Mar 08, 2015 3:42 pm
Location: New York State

Re: Is this a home made data separator?

Post by lowrybt1 »

Actually, I found it only for $10 and purchased it. I've tested it with a C4PMF without success. On closer inspection, there are a couple of solder joints that are bad. I will fix those soon and try again. I'm surprised that there is no variable resistor for fine-tuning. That's been a component of all other data separator boards I've come across.
C8PDF w. 48K, 2x 520 24K RAM boards and Glitchworks 64K board
OSI 567 Telephony board
Spare 8" drives
Klyball D-13
Mark
Posts: 292
Joined: Tue Sep 16, 2008 6:04 am
Location: Madison, WI
Contact:

Re: Is this a home made data separator?

Post by Mark »

The other things that comes to mind is perhaps it is a "disk saver" automatic motor off circuit. My C4P has one that I incorporated years ago to shut off the spindle motor if there is no disk activity. I had it hanging off the A13 board too. Its been too long but I think it monitored head load, and maybe step. It used a large capacitor & one-shot & glue logic to generate a ~30+ second long delay. This worked fine for years until the capacitor failed or was disconnected, and caused me some problems trying to read disks. The drive would shut off mid-disk read.

Back when OSI was new, one of the guys in the OSI users group I belonged to had a floppy that you could see though after weeks/months of sitting in the drive spinning letting the oxide rub off. It was amazing that it still booted!

Cheers,
-Mark
Post Reply